240Z rear Strut Brace

1. Remove strut tower caps.

2. Remove the three tower nuts.

3. Put strut plates in place and re-tighten nuts.

4. Place strut bar in place insert top bolts to hold brace in place and mark where the leg brackets need to be drilled.

5. You may have to open the brackets in order to clear vinyl.

6. Remove strut brace and drill both sides of the support with a 5/16" drill bit.

7. Re-install the strut brace and install bolts top and bottom and tighten.

 

Copyright © 1998 [PDK Fabrication]. All rights reserved